How to Properly Wear BACtrack Skyn

Your BACtrack Skyn should be worn on your non-dominant hand (if you're right handed, wear it on your left and vice versa), on the underside of your wrist, opposite the location of where a watch would go

To wear your Skyn correctly, follow these simple steps:

  1. Fold your thumb inwards to make enough room for the band to slide over your hand.
  2. Slide your Skyn down to just below your wrist joint, making sure the white sensor circle is positioned on the inside of your wrist.
  3. Tighten the band by pulling the end and placing the magnetic piece on the band itself. The strap should be tight, but not uncomfortable.
  4. Be sure to periodically make sure the band remains tight. A loose band could affect the performance of BACtrack Skyn.

Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.